Vtp not updating packet tracer Free arabic sex video chat
On Switch C we will create four VLANs 10, 20 30 and 40.VLAN 10 and 20 are already configured, We’re just naming them here: If we go to Switch B and switch A and issue a show vlan command we will notice the two VLANs have automatically been created for us: Switch B: Lets try and configure VLAN 50 on Switch A: We are unable to do so! VTP Pruning isn’t supported as of writing this on Packet Tracer version 5.3.3.
This will stop the advertisement of unused VLANs to other switches.Cisco’s documentation on VTP version 2 transparent mode states that it will pass VTP messages without inspecting the domain name. We are going to use the simple topology below to test this. Here is the VTP status of the switches in our topology.Let’s start with a basic configuration for all three switches that we know will work. Only the default VLANs currently exist on these switches.Let’s add VLANs 10, 20, and 30 to verify that VTP is working across all three switches.I will use the following commands on SW1 only to create three VLANs.
After that we will configure trunking in our practice lab. In this part we will provide a step by step guide to configure the VLAN.